Owner's Manual

EXP1240 Admin Guide, Version 2.0
Proprietary and Confidential
Chapter: Appendix C: EXP1240 Network Planning/Optimization
113
Collect statistics of the network an example is illustrated in the table below:
Parameters Value Comments
## Call Setup failures
## Dropped calls
## HO successes
## HO failures
Traffic Blocking Rate
(%)
Traffic Blocking (Erl)
Receiver level (dBm)
Receiver Quality (%)
After collecting the necessary information, you should fine tune signalling and radio resource sharing
parameters. Network optimisation is a continuous process during and after the launch of the network.
For example, if it is found that an area within a building has low signal level. There should be an immediate
scrutiny of base station and/or repeater locations, heights and tilts. The problem is sorted out by moving
the relevant devices and altering the tilts of these devices.
For buildings/halls constructed with high signal attenuation materials, deploying additional base stations
will be one of the solutions.