Owner`s manual

Using the Phonebook

The base can store up to 200 entries in its phonebook. All handsets share the same

phonebook, so only one handset can access it at a time.

To... Press...

open/close the phonebook

Press MENU/OK and select Phonebook and press

scroll through the entries

DOWN to scroll through the entries from A to Z.

UP to scroll from Z to A.

jump to entries that start with a

certain letter

the number key corresponding to the letter you

want.

dial the current entry

TALK/FLASH or SPEAKER.

edit the current entry

MENU/OK, then select Edit.

delete the current entry

MENU/OK, then select Delete. To confirm, select Yes.

To add a new phonebook entry (with the phone in standby), open the phonebook. Press

MENU/OK and select Create New. Enter a name and number, then select a personal ring.

To add the current number to the phonebook, press MENU/OK and select Store into Pb.

The Edit Name screen displays. Edit the information.

• Enter the phone number (up to 32 digits) exactly as you would dial it.

• If you need to enter a pause between the numbers, press REDIAL/PAUSE; you’ll see P in

the display. (The dialing will pause for about 3 seconds per a digit.)

• To edit the number, press END/CLEAR or MUTE/DELETE to back up the cursor and delete

numbers. Re-enter the correct numbers.

Adding/Editing Phonebook Entries

Deleting All the Phonebook Entries

With the phone in standby, open the phonebook. Press MENU/OK. Select Delete All. To

confirm, select Yes.

Chain Dialing

If you often have to enter a series of digits or a code number during a call, you can save

that code number as a regular phonebook entry and use the phonebook to send the

code number.

1. Make your call normally. When you hear the prompt that asks you to enter your code

number, open the phonebook and find the entry.

2. Press MENU/OK to send the code. If you change your mind, just close the phonebook.