User`s guide

English - 3
GETTING STARTED
Installing Your Phone
Charge the Battery
1. Unpackallhandsets,
batterypacks,and
batterycovers.Ifyou
needtoremovea
cover,pressinonthe
notchandslidethecoverdownand
off.
2. Lineupthebatteryconnectorwith
thejackinsidethehandset;the
connectoronlyfitsoneway.
3. Pushtheconnectorinuntilitclicks
intoplace;tuggentlyonthewires
tomakesurethebatteryissecurely
connected.
4. Replacethebatterycoverandslideit
intoplace.
5. UseanACadaptertoconnectthe
powerjackonthebasetoaregular
indoor(120VAC)poweroutlet.
Connectanychargersthesameway.
6. Placeahandsetinthebasewith
thedisplayfacingforward.Ifthe
StatusLEDdoesn’tlightup,reseat
thehandsetorconnectthebase
toadifferentoutlet.For2ormore
handsets,placeeachhandsetina
charger.
# Charge all handsets completely
(about 15 hours) before using.
Connect the Telephone Cord
Usethetelephonecordtoconnectthe
TELLINEjackonthebasetoastandard
telephonewalljack.
Test the Connection
1. Pickupthehandsetandpress
TALK/
FLASH
.Thehandsetsoundsadial
tone,andthedisplayshows Talk .
– Ifyoudon'thearadialtoneorthe
displaysays
Check Tel Line, check
theconnectionbetweenthebase
andthephonejack.
2. Makeaquicktestcall.(Press
End to
hangup.)
– Ifyoukeephearingadialtone,
changetopulsedialing.
– Ifthere’salotofnoise,checkfor
interference(seepage20).
3. Testallhandsetsthesameway.If
youcan'tgetadialtone,movethe
handsetclosertothebase.
Changing to Pulse Dialing
Yourphoneusestonedialingbydefault.
Ifyourphonecompanyusespulse
dialing,youneedtochangeyourphone’s
dialmode.
1. Press
MEnu/SELEcT ;choose Global
Setup .
2. Select
Dial Mode then Pulse .You’ll
hearaconfirmationtone.
TosendDTMFtonesduringacall(e.g.,
foranautomatedresponsesystem),
press
*
totemporarilyswitchtotone
dialing.Whenyouhangup,thephone
automaticallyreturnstopulsedialing.
Attaching the Belt Clip
Lineuptheholesoneachsideofthe
handset.Insertthebeltclipintothe
holesoneachsideofthehandset.Press
downuntilitclicks.
Toremovethebeltclip,pulleitherside
ofthebeltcliptoreleasethetabsfrom
theholes.
Attaching Optional Wall Mount
Bracket
Youcanorderawall-mountbracket
fromtheUnidenwebsite.Followthe
instructionsthatcomewiththebracket.