User`s guide

English - 21
Installing a Line Filter or DSL
Filter
AtelephonelinefilterorDSLfilter
preventsservicesthatusethephone
linefromcausinginterferenceonyour
phone.Togetalinefilter,contact
yourserviceproviderorlookinan
electronicsstore.
Plugthefilterintothetelephonewall
jackandplugthebaseintothefilter.
Makeatestcalltomakesurethenoise
isgone.
Liquid Damage
CAUTION: If the base is covered in
liquid, disconnect the adapter &
phone cord from the wall before
touching it.
Iftheliquidisonlyontheexterior
housingofthebaseorhandset,wipeit
offanduseasnormal.Ifyoucanhear
liquidinsidethehousing:
1. Removeallcompartmentcovers,and
disconnectallcablesandcords.
2. Ifliquidisleakingfromanyvent
orhole,turnthephonesothatvent
facesdown.Ifnot,placethelargest
ventfacedown.
3. Letdryforatleast3days.Check
forliquidinsidethephonebefore
replacingcompartmentcovers&
reconnectingcords.
Resetting Handsets
Ifyouhavetroublewithahandsetor
ifyouwanttoreplaceone,clearthe
registrationinformationfromthebase
andthehandset:
1. Press&hold
End and
#
atthesame
timeuntilyouseethe System Reset 
menu.
2. Ifyoustillhavethebasethehandset
isregisteredto,select
Deregister HS ,
thenselectthehandsetyouwant
toreset.Ifyoudon’thavethatbase
anymore,select Base Unavailable .
3. Toconfirm,select
Yes .Thehandset
displays Handset not registered .
Registering Handsets
Ifyouseea“notregistered”messageon
ahandset,youmustregisterittoabase
beforeusingit.
1. Placethehandsetinthebase;
thedisplayshouldsay
Handset
Registering .
2. Waituntilthedisplaysays
Registration Complete (about30
seconds),thenpickupthehandset;
press TALK/FLASH .
3. Ifyoudon’thearadialtoneorthe
displaysays
Registration Failed ,
chargethebatterycompletely,then
tryagain.
Adapter and Battery Information
AC adapter Base Charger
Partnumber PS-0035 PS-0035
Inputvoltage 120VAC,60Hz
Outputvoltage
8VAC@
300mA
8VAC@
300mA
x UseonlythesuppliedACadapters.
x Usetheproperadapterforthebase&any
chargers.
x Donotplacetheunitindirectsunlightorsubject
ittohightemperatures.