Owner's Manual
14 - English
Answering system problems Possible solutions
I can’t hear the base speaker.
x Make sure call screening is turned on.
x Change the base speaker volume.
Messages are incomplete.
x Increase the Record Time.
x Delete messages (memory may be full).
The system keeps recording
when I answer on an extension.
x You may have to change the line mode.
Contact Customer Service for instructions.
Installing a Line Filter or DSL Filter
x A telephone line filter or DSL filter prevents services that use the phone line
from causing interference on your phone. To get a line filter, contact your
service provider or look in an electronics store.
x Plug the filter into the telephone wall jack and plug the base into the filter.
Make a test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter and
phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it off
and use as normal. If you can hear liquid inside the housing:
1. Remove all compartment covers, and disconnect all cables and cords.
2. If liquid is leaking from any vent or hole, turn the phone so that vent faces
down. If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before
replacing compartment covers and reconnecting cords.
Adapter and Baery Informaon
AC adapter Base Charger
Part number PS-0035 PS-0035
Input voltage 120V AC, 60 Hz
Output
voltage
8V AC @
300mA
8V AC @
300mA
Battery pack (with normal use)
Part number BT-1021
Capacity 300mAh, 2.4V DC
Talk time about 7 hours
Standby time about 6 days
Battery life about 1 year
x Use only the supplied AC adapters.
x Use the proper adapter for the base
and any chargers.
x Do not place the unit in direct
sunlight or subject it to high
temperatures.
x Replace the battery when the talk
or standby time becomes noticeably
reduced. For replacements, call the
Parts Department (see the front
cover).
x When the battery gets low, the
handset beeps or shows a low
battery alert; put the handset in the
cradle for recharging.