Owner's Manual

12 - English
To... From the base From a handset
hear the caller leaving a
message
Listen to the caller
over the speaker.
Press
MEssagE/MuTE .
answer the call NA Press
TaLk/fLash .
mute the call screen
without answering*
Press
pLay/sTop .
Press
ENd or return the
handset to the cradle.
* If you mute the call screen, the system continues taking the message: it just stops
playing through the speaker.
Using the System While You’re Away from Home
You can dial in to your answering system from any touch-tone phone. Before
you can use this feature, you must program a security code.
Programming a Security Code
With the phone in standby, open the menu; select Answering Setup, then select
Security Code. Use the number keypad to enter a two-digit security code (01 to
99). Press
MENu/sELEcT when you’re finished.
# Remember to make a note of your new security code!
Dialing In to Your System
1. Call your phone number from any touch-tone phone, and wait until the
system answers.
x If you have the Ring Time set to Toll Saver, the system answers after 2
rings if you have new messages and 4 rings if you don’t. You can hang
up during the third ring.
x If the system is turned off, it answers after 10 rings and beeps sound.
2. During the greeting or beeps, press
0 and
immediately enter your security code. If you
enter it incorrectly 3 times, the system hangs
up and returns to standby.
3. The system announces the time, the number
of messages in memory, and a help prompt.
It beeps to let you know it’s waiting for a
command; enter a 2-digit command from the
chart.
# If you don’t press any keys for 15 seconds,
the system hangs up and return to
standby.
01 Repeat message
02 Play message
03 Skip message
04 Delete message
05 Stop playback
06 Turn the system on
09 Turn the system off
10 Hear help prompts