User manual

2.15 Modify the software bandplan.
The BR330T has a build in Automode bandplan, this means that when you
enter a frequency, the scanner will select receive mode from a preset list (see
page 10-11 of BR330T user manual).
ARC330 also uses this bandplan, by default mode of new frequencies is set to
Auto. You can change this behaviour.
In the systembrowser click on a conventional group. In the menu select SETUP
_ BANDPLAN:
The STEP column is only valid for BC246T, the BR330T and BR330T do
not use step settings anymore.
Here you can modify the behaviour for a frequency range. Rules must be
enabled before they are used by the software. The bandplan is stored and
remembered.
Rules are applied from top to bottom, rules can overlap.
In this example the software will select ‘FM’ instead of ‘NFM’ for the 400.0 –
500.0 MHz range and 144.500 – 146.00 range.
For your convenience the default bandplan is shown, in Auto mode this is the
bandplan that is used, in this editor you program exceptions to the standard
bandplan.
ARC330 Software User Manual 102- 45