User manual

2.4 Default data:
When you enter a frequency or ID and you press ENTER the other cells of that
line are automatically programmed depending on your custom settings (default
channel data). You can customize the default data: select SETUP _ SETUP
DEFAULT DATA. A new window is shown:
In this window you set the default data that is put in the grid when you press
enter. All parameters that have the check box selected will be put in the grid.
By using this option the software will take care of programming default data.
Mode and step column: By default both step and mode are set to auto, so the
scanner uses the internal database to lookup mode and step.
Tip: programming your personal preferences in the default data and setup a
custom bandplan will save you time while programming new frequencies/id’s.
When you press <enter> the software will automatically go to the next cell.
2.5 Sort channels
Memory channels can be sorted. You can either sort ascending or descending.
You can only sort within a single group. In general scanners will scan faster
when channels in a bank are sorted.
Sort a range of channels: highlight the range of channels you want to sort, and
then select the sort option. Only the selected range of channels will be sorted.
ARC330 Software User Manual 102- 25