User`s guide

ScanControl

One Program, Multiple Scanners, Made in USA

be able to hear the radio’s audio coming from the PC speakers if your channels have been

programmed to enable Record Out. The general rule of thumb is the volume level you hear from

the PC speakers will be the volume level that is recorded by IAC, however, you should use the

audio level bar graphs in the IAC section of the ScanControl Control / Monitor screen to verify

the proper level.

Figure 51 - PC Audio Control

3. Configuring IAC Program Options – Start ScanControl with your radio connected via the

serial cable as you would normally and the audio cable as described above. Open the Program

Options screen and set the Audio Device, Audio Device Line, Wave Format and Group by

options as appropriate for your configuration. You should not have to adjust the THold setting,

100 is the recommended value. Save these settings and close the Program Options screen.

Figure 52 - IAC Program Options

4. Enabling / Disabling Recording for Channels / TGIDs – ScanControl supports the construct

of having an individual Record Out attribute for each channel / TGID in a bank or system and for

a particular search range. IF THESE RECORD OUT ATTRIBUTES ARE NOT ENABLED

IN THE RADIO AND IN SCANCONTROL (R box checked on the Bank, ScanList, System

or Group Edit Screens) THEN SCANCONTROL WILL NOT RECORD THE AUDIO,

EVEN IF THE AUDIO CAN BE HEARD COMING THROUGH THE PC. Referencing the

table of radio types above, some radios support a Record Out attribute in the radio, others do not.

Those that do require that you check the R box for the channel / TGID and then program the data