User`s guide

ScanControl
One Program, Multiple Scanners, Made in USA
Copyright  2009 – 3D Technologies Page 27 of 86
Figure 21 - Motorola Custom Band Plan Screen
Motorola Custom Band Plan Screen – Selecting a trunk system/site type of M-800C will enable the
“Edit Bandplan” button on the bottom of the System Editor screen. Clicking the Edit Bandplan button
will open the Custom Bandplan screen above.
• Trunk Table Grid
o Custom Trunk Table Entry Rows – Some Motorola Trunk Systems require the entry of
custom trunk system values into the radio to insure proper monitoring. The Trunk Table
screen provides an input entry screen for these values.
• Edit Section
o Copy Dn Button - Copies a cell, or range of cells in a row, to all the highlighted cells
below the selected cells. This is very handy for quickly repeating values into the rows
below selected cells.
o Cut Row Button – Cuts a row of values out of the grid and places them into the
clipboard for later pasting.
o Copy Button - Copies a cell, or range of cells, into the clipboard for later pasting
o Paste Button - Pastes the clipboard data resulting from a Cut Row or Copy action.
o Undo Button - Reverses the last Copy Dn, Cut Row, Copy, Paste or DataGrabber Paste
action.
o Move Up Button - Move the selected row up one row.
o Move DnButton - Move the selected row up one row.
• Operation Controls
o Close Button – Click to close the Trunk Table screen.
APCO Band Plan # (BCD996T Only) – Drop down list of available Band Plans for APCO MP25
systems for the radio in use. This is a value between 1 and 32. By selecting a plan # you are selecting