User Guide

46
Other Settings
• Priority On: While scanning a conventional system,
the scanner interrupts every 2 seconds and checks
the priority channels in each unlocked conventional
system. Priority channels in lower priority key num-
bered systems (starting from 1) have highest priority.
Pri appears when you select this mode.
• Priority Plus: The scanner only scans priority
channels in unlocked conventional systems.
Pri flashes when you select this mode.
Other Settings
Using the Backlight
  Set Backlight  E
•
10 sec The backlight stays on for 10 seconds after
you press .
•
30 sec The backlight stays on for 30 seconds after
you press .
•
Squelch The backlight turns on when the squelch
opens then stays on for 5 seconds.
•
Keypress The backlight turns on when any key is
pressed then stays on for 10 seconds.
•
Infinite The backlight turns on when you press
then stays on until you press again.
Pressing any key while the backlight is on extends the
backlight period. Pressing while the backlight is on
turns off the backlight.
Initializing the Scanner’s Memory
To initialize the scanner’s memory, turn off the scanner.
Then, press 2, 9, and Hold while turning it on.
Important! This deletes all preprogrammed data.
You cannot restore preprogrammed data that has
been deleted.
Menu