Radio User Manual

61
Programming Radio Systems
When the scanner prompts Confirm?, press E to accept
the settings. The scanner creates an empty LTR system,
with a default name of System nnN L.
nNn increments as you add new systems. L indicates that
this is an LTR system.
Next, refer to the appropriate section to set system-wide
options. For most settings, you can accept the default.
However, for the items in bold, you must enter informa-
tion in order for your scanner to scan the system.
• See “Editing the System Name” on Page 63
• See “Setting the System Hold Time” on Page 64
• See “Editing the System Quick Key” on Page 63
• See “Setting the Channel Delay Time” on Page 65
• See “Setting ID Scan/Search (Trunked Systems
Only)” on Page 65
• See “Reviewing Locked Out Frequencies” on
Page 89
• See “Setting Channel Attenuation (Conventional
Channels Only)” on Page 77
• See “Deleting Systems” on Page 71
• See “Copying Systems” on Page 71
• See “Setting System Frequencies” on Page 61
• See “Entering/Editing LTR Channel Groups” on
Page 61
Setting System Frequencies
SET FREQUENCIES  E
 New FREQUENCY  E
Input a system frequency, then press E. The scanner then
prompts you to enter the LCN for the entered frequency.
Enter the LCN, then press E.
To enter additional frequencies, press , use the scroll
control to select New Frequency, then repeat the above.
Entering/Editing LTR Channel Groups
To enter channels in a system, first set up a channel
group (or groups) to hold the channels. Then, enter the
channel and channel parameters in the group(s).
Menu
BC246T Paper OM 062405.fm Page 61 Tuesday, June 28, 2005 10:12 AM