Radio User Manual

59
Programming Radio Systems
• See “Setting the EDACS ID Format (EDACS Systems
Only)” on Page 69
• See “Reviewing Locked Out Frequencies” on
Page 89
• See “Setting Channel Attenuation (Conventional
Channels Only)” on Page 77
• See “Deleting Systems” on Page 71
• See “Copying Systems” on Page 71
• See “Setting System Frequencies” on Page 59
• See “Entering/Editing EDACS Channel Groups”
on Page 59
Setting System Frequencies
SET FREQUENCIES  E 
  NEW FREQUENCY E
Input a system frequency, then press E. The scanner then
prompts you to enter the LCN for the entered frequency.
Enter the LCN, then press E.
To enter additional frequencies, press , scroll to New
Frequency, then repeat the above.
Note: The scanner only accepts a single frequency and
no LCN for SCAT systems.
Entering/Editing EDACS Channel Groups
To enter channels in a system, first set up a channel
group (or groups) to hold the channels. Then, enter the
channel and channel parameters in the group(s).
Setting Up a Channel Group
  EDIT GROUP E 

 NEW GROUP E
The scanner creates a group with a default name of
GROUP nn. nn increments by one for each new group you
create within a system.
Next, refer to the appropriate section to set group-wide
options:
Menu
BC246T Paper OM 062405.fm Page 59 Tuesday, June 28, 2005 10:12 AM