Radio User Manual

58
Programming Radio Systems
To program another channel within the same group, press
, then repeat the above.
To create another channel group and enter more
channels, press three times, then proceed from
“Entering/Editing Motorola Channel Groups” on Page 56.
Programming EDACS Systems
 Program SysteM  E 
New System  E  EDCS  E
Next, rotate the scroll control to select the type of EDACS
system you will program, then press E.
• WIDE - Use for wideband EDACS systems
• NARROW - Use for narrowband EDACS systems
• SCAT - Use for EDACS SCAT (Single Channel
Autonomous Trunking)
When the scanner prompts Confirm?, press E to accept
the settings. The scanner creates an empty EDACS
system, with a default name of System nnN E.
nnN increments as you add new systems. The E indicates
that this is an EDACS system.
Next, refer to the appropriate section to set system-wide
options. For most settings, you can accept the default.
However, for the items in bold, you must enter
information in order for your scanner to scan the system.
• See “Editing the System Name” on Page 63
• See “Editing the System Quick Key” on Page 63
• See “Setting System Lockout” on Page 64
• See “Setting the System Hold Time” on Page 64
• See “Setting the Channel Delay Time” on Page 65
• See “Setting ID Scan/Search (Trunked Systems
Only)” on Page 65
• See “Setting I-Call (Motorola and EDACS Systems
Only)” on Page 68
• See “Setting Emergency Alert (Motorola and EDACS
Systems Only)” on Page 69
Menu
Menu
Menu
BC246T Paper OM 062405.fm Page 58 Tuesday, June 28, 2005 10:12 AM