Radio User Manual

53
Programming Radio Systems
Programming Conventional Systems
 Program SysteM  E 
New System  E  Conventional 
E  Confirm?  E
The scanner creates an empty conventional system, with
a default name of System nnn C. nnn increments
as you add new systems. C indicates that this is a
conventional system.
Refer to the appropriate section to set system-wide
options:
• See “Editing the System Name” on Page 63
• See “Editing the System Quick Key” on Page 63
• See “Setting System Lockout” on Page 64
• See “Setting the System Hold Time” on Page 64
• See “Setting the Channel Delay Time” on Page 65
• See “Setting Data Skip (Conventional Systems Only)”
on Page 66
• See “Deleting Systems” on Page 71
• See “Copying Systems” on Page 71
• See “Entering/Editing Conventional Channel Groups”
on Page 53
Entering/Editing Conventional
Channel Groups
To enter channels in a conventional system, first set up a
channel group (or groups) to hold the channels. Then,
enter the channel and channel parameters in the group(s).
Setting Up a Channel Group
  Edit Group  E 
  New Group  E
The scanner creates a group with a default name of
Group nn. nn increments by one for each new group you
create within a system.
Menu
BC246T Paper OM 062405.fm Page 53 Tuesday, June 28, 2005 10:12 AM