Specifications
Table Of Contents
- Welcome
- Installing the Phone
- Getting to Know Your New Phone
- Using the Interface
- Basic Setup
- Setting Up the Phonebook and Speed Dial
- Creating Phonebook Entries
- Finding a Phonebook Entry
- Editing an Existing Phonebook Entry
- Storing Caller ID or Redial Numbers in the Phonebook
- Deleting a Single Phonebook Entry
- Deleting all Phonebook Entries
- Copying Phonebook Entries to Another Handset
- Programming Base One-touch Dial Numbers or Speed Dial Numbers
- Customizing Your Handsets
- Using Your Phone
- Using Caller ID, Call Waiting, and Redial Lists
- Adjusting the Ringer, Earpiece and Speaker
- Finding a Lost Handset
- Using Hold, Conference and Transfer
- Using Special Features
- Maintenance
- Troubleshooting
- Precautions!
- One Year Limited Warranty
- Index
13
14
Installing the Phone
Place the mounting
slots over the pins
on the wall plate.
Slide the base
down to lock it
into place.
Wall plate
At the bottom of the base, lift up on
the release latch between the two
bottom tabs and push the bracket up.
Removing the wall-mount bracket
(To AC outlet)
Release latch
Note: Mounting the phone directly on the wall
Be sure the wall is capable of supporting the weight
of the phone, and use the proper type of anchoring
device for the wall material.
Insert two #10 screws (minimum length of 1
3
/
8
inches, not supplied) into the wall, 3
15
/
16
inches
apart.
Leave the screw heads
1
/
8
inch away from the wall to
allow room for mounting the phone.
Align the mounting slots over the screws and slide
the base down into place as shown above.
•
•
•
•