User's Manual

Appendix 1: Tracker Event List
This table shows the different events/ messages sent from the device.
There are more than 9 different situations that can trigger the device to respond to positioning commands and
tracker status messages as the following.
Note: Any event marked with the letter “B” represents data which failed to send through specified route due to
priority or mobile network service issue. Check whether the data is sent after network issues are cleared.
Event
Description
AUTO / BAUTO
When the device is set to report to assigned route in a given period of time, it will
send a report automatically with an AUTO message.
When any other event is triggered and the priority is greater than AUTO, the
Retrospective Location report will be backed up and reported to assigned route later.
POLL / BPOLL
When sending polling command to poll the report, it triggers the POLL event.
LP2
When the equipment is in the lowest power, it triggers the “LP2” event.
TT
When the residential equipment tamper switch is detected, it triggers the “TT”
event.
MT
When the residential equipment is moved, it triggers the “MT” event.
PLUG
When the equipment is plugged in charger for more than 10 seconds, it triggers the
“PLUG” event.
UNPLUG
When the equipment is unplugged from charger, it triggers the “UNPLUG” event.
CHOK
When the equipment is full charged, it triggers the “CHOK” event.
RFIN
When the equipment is receiving RF signal from bracelet, it triggers the “RFIN”
event.
11F., No.2, Sec. 4, Jhongyang Rd., Tucheng Dist., New Taipei City 236, Taiwan (R.O.C.)
Tel: [phone]｜Fax: [phone]｜[e-mail]
47
w
w
w
w
w
w
.u
.
n
sa
ic
n
tr
a
o
v
n
.
.
c
c
o
o
m
m
© Unictron Technologies Corp.
All specifications subject to change without notice.