User's Manual

11F., No.2, Sec. 4, Jhongyang Rd., Tucheng Dist., New Taipei City 236, Taiwan (R.O.C.)
Tel: [phone]｜Fax: [phone]｜[e-mail]
9
www.etek.com.tw
© Unictron Technologies Corp. All specifications subject to change without notice.
www.sanav.com
www.unictron.com
5. Please note that the cutting line should
be on the groove between two scales
for easy cutting and wearing purpose.
6. While cutting the strap by using the
dedicated strap, it should proceed with
3 stages cutting procedures. Keep
cutter and strap at 90-degree angle to
make sure that the cutting edge should
be flat.
(1) 1
ST
stage: Cut slowly from strap
edge to 2/5 of strap width (as
marked “1” of right picture).
(2) 2
nd
Stage: Continue to cut 1/5 of
strap width, where is the fiber
optical wire, by one-time cut to
avoid from bumpy cutting edge
(as marked “2” of right picture).
(3) 3
rd
Stage: Continue to cut 2/5 of
strap width (as marked “3” of right
picture).