User's Manual

11F., No.2, Sec. 4, Jhongyang Rd., Tucheng Dist., New Taipei City 236, Taiwan (R.O.C.)
Tel: [phone]｜Fax: [phone]｜[e-mail]
41
www.etek.com.tw
© Unictron Technologies Corp. All specifications subject to change without notice.
www.sanav.com
www.unictron.com
Power Saving Mode Setup
This mode has two part of feature.
In Power Saving Mode 0, the battery life can be saved by stopping GPS output temporarily while the device
isn’t reporting. This is the default setting.
Set <Power Saving Mode> to 0 to enable it such like this command: #username,0000,combo,0*.
In Power Saving Mode 1, power save mode will be disabled and the GPS is always on. If the GPS signals are
often poor in your environment, to use this mode is recommended.
Set <Power Saving Mode> to 1 to disable it such like this command: #username,0000,combo,1*.
Setup Format: #<User Name>, <Password>, <Function Mode>, <Power Saving Mode>*
Command: #username,0000,combo,3*
Table: Power Save Mode Setup Format Description
Situation
Description
Success
[username] +, Device Combo mode has been deactivated.
Table: Power Save Mode Setup Response Description
SMS Text
Description
#
Start sign.
username
 Default user name of the device.
 If you have changed the username, please use the updated one.
0000
 Default password.
 If you have changed the password, please use the updated one.
combo
Mode ‘combo’ defines Power Save mode
1
0
Power Saving mode 0. The basic power save interval is 30 seconds. The device
will try to get valid position data every 30 seconds and the interval will be
accumulated (30, 60, 90, 120…etc) if successful (well positioned), or start from
30 sec. interval.
1
To disable the Power Saving mode. GPS will always on.
*
End sign.