User`s manual

User’s Manual 35
․IDE Primary Master/Slave UDMA and IDE Secondary
Master/Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is selected, the
BIOS will select the best available option after checking your hard drive or
CD-ROM.
․On-Chip Serial ATA
Disabled
Disables the onboard SATA.
Auto
The system will detect the existing SATA and IDE drives
then automatically set them to the available master/slave
mode.
Combined Mode
This option allows you to use both IDE and SATA drives;
allowing a maximum of 4 drives. You must manually set
the SATA drives’ master/slave mode in the “Serial ATA
Port0 Mode” and “Serial ATA Port1 Mode” fields.
Enhanced Mode
This option allows you to use both IDE and SATA drives;
allowing a maximum of 6 drives.
SATA Only
This option automatically sets the SATA drives to Primary
Master and Secondary Master modes. Since both drives are
in master mode, you cannot set the IDE drives to Master
mode. The “Serial ATA Port0 Mode” and “Serial ATA
Port1 Mode” fields will not be configurable.
․
SATA PORT Speed Settings
The SATA PORT Speed Settings option controls the maximum access speed
allowed for the connected SATA devices, with the GEN I setting used for
SATA-150 type devices and GEN II used for SATA II type devices.
․PATA IDE Mode
These fields are used to select the master/slave mode of the serial ATA drives.
Make sure they do not conflict with the settings of the IDE hard drives.
․USB Controller
Select “Enabled” if your system contains a Universal Serial Bus (USB) controller
and you have a USB peripheral.
36 The ENDAT-9401F/H System Board
․USB 2.0 Controller
The options for this field are Enabled and Disabled. By default, this field is set to
Disabled. In order to use USB 2.0, necessary OS drivers must be installed first.
․
AC97 Audio Select
The AC97 Audio Select option allows the user to enable or disable onboard
audio function.
․UART Mode Select
Select an operating mode for the serial port 2.
<Choice: IrDA, ASKIR, Normal>
․Parallel Port Mode
This field allows you to determine parallel port mode function.
<Choice: SPP, EPP, ECP, ECP + EPP, Normal>
․PWRON After PWR-Fail
This item allows you to select if you want to power on the system after power
failure