Instruction manual

.LON 100

Hardware Guide 3

6. Open the Windows Command Prompt window and enter the following

command (this is the exact text of the command):

route add 192.168.1.0 mask 255.255.255.0 %COMPUTERNAME%

This command allows your computer to communicate with the

.LON 100

server’s default IP address (192.168.1.222), even when they are on

different subnets. This command will not persist through computer

reboots. However, you can add it to your computer’s startup script.

7. To confirm that you have successfully connected your

.LON 100, launch

Internet Explorer 6 or later and go to the following website:

http://192.168.1.222

8. The

.LON 100 Internet Server Welcome Web page appears. Following

this, you can configure the

.LON 100 server with the Web pages and

begin using its applications, as described in the

LON 100 Internet

Server User’s Guide

Mounting the Enclosure

Safety Warning

The

.LON 100 Internet Server is intended to be mounted inside a suitable,

safety-agency approved enclosure that is mounted in a restricted access area.

High-voltage wiring must be performed only by a qualified service person.

Before connecting the wiring on the

.LON 100 Internet Server, Echelon

recommends that you mount it inside an enclosure. The

.LON 100 Internet

Server mounts to a 35mm x 7.5mm or 35mm x 15mm DIN rail located inside a

suitable, safety-agency approved enclosure. It should be mounted in a restricted

access area. The rear of the

.LON 100 server enclosure contains a spring-loaded

DIN rail lock, which securely grabs the DIN rail onto which the enclosure is

mounted.

To release the enclosure from the DIN rail, insert a flathead screwdriver into the

DIN rail locking tab and gently pull the tab downwards and away from the

enclosure. Figure 1.1 shows the location of the DIN rail-locking tab (circled in

red).