Instruction manual

.LON 100

Hardware Guide

RJ-11 Telephone Line Port

Safety Warning

The

.LON 100 server’s telephone modem should only be used with telephone

circuits equipped with proper lightning and transient protection circuitry.

This minimizes the risk of shock or damage should lightning strike on or near

a telephone circuit to which the

.LON 100 server is connected.

The RJ-11 telephone connector is used with

.LON 100 Internet Server Models

72102 and 72104, which contain an analog modem the

.LON server can use to

make dial-out calls. This connector must be used with a suitable male RJ-11

connector that is connected to a two-wire POTS connection that is compatible

with the V.90 internal analog modem. The

.LON 100 server analog modem is

not compatible with ISDN circuits.

CAUTION – To reduce the risk of fire, use only No. 26 AWG or larger

telecommunication line cord.

Applying Power to the i.LON 100 Internet Server

Once you have mounted the

.LON 100 Internet Server, connected all wiring, and

closed the enclosure, apply AC mains power to the unit. The LEDs on the

.LON

100 server will flash for several minutes as the unit boots. Once the unit is

powered and operational, the green Power/Wink LED will stay solid ON.