Instruction manual

.LON 100

Hardware Guide

Figure 1.12

.LON 100 Server LONWORKS +12V < 20mA Output

Terminals

Table 1.7 lists the enclosure markings for the 12V <20mA output screw

terminals.

Table 1.7

.LON 100 Server LONWORKS +12V < 20mA Output Terminals

Connections

Screw Terminal Enclosure Marking +12V < 20mA Connection

19 GND Ground

20 +12V < 20mA +12 Volt output.

RJ-45 10/100 BaseT Ethernet Port

After you have connected all the required screw terminal connectors for your

system, you should connect the RJ-45 10/100 BaseT Ethernet port to a 10BaseT

or 100BaseT Ethernet channel. This will connect the

.LON 100 server to the

Ethernet network, and allow you to configure the

.LON 100 server with the Web

page software.

The RJ-45 connector must be used with an RJ-45 male connector and a suitable

Category 5 or Category 6 data cable. The

.LON 100 server will automatically

adjust to the speed of the data port, and will illuminate the Link and 100 LED

indicators on the front panel if a 100BaseT network connection is established (the

Link LED indicates that a connection has been established, and the 100 LED

indicates that the connection is to 100BaseT network). The

.LON 100 server will

automatically detect whether it is connected to an Ethernet hub or directly to a

computer, so it is not necessary to use a crossover Ethernet cable.

DB-9 Console Port

The

.LON 100 server contains a console application that you can access with a

terminal emulation program such as Windows HyperTerminal via the EIA-232

DB-9 console port. This application allows you to set basic parameters such as