User's Guide

U3 USER GUIDE
41
12. TOOLS
12.1 USING ALARM FUNCTION
12.1.1 To Enable Alarm Function
1. In standby mode, press the Menu button to enter main Menu.
2. Use 4-way Navigator button to move highlight bar to
“Alarm” function.
3. Press Menu & Enter button to confirm selection and enter next
menu.
4. You will be able to see two sets of alarms with ON/ OFF status.
If alarms have been set, it will show the set time. Press right
soft button “Change” to enable the alarm by using 4-way Navigator button ▲▼ to select
ON status.
12.1.2 How To Set An Alarm
1. Press the 4-way Navigator button ▲▼ to select ON status.
2. Press Menu & Enter button to set Alarm.
3. The time settings will start with “Hour” first by using key pad in
numeric format.
4. Use 4-way Navigator button ◄► to switch between “Hour”
and “Minute”.
5. Press left soft button “Next” to go to next step.
6. Press Menu & OK button or wait for three seconds to go back
to the Alarm menu.
12.1.3 Response To A Time Alert
1. When the clock is on the set alarm time, it will trigger the alarm
and radio will sound alert.
2. If the alarm is not stopped in one minute, or press other
buttons other than “Close” button, the alarm alert will
temporary close. The alert will trigger again after 10 minutes.
3. If user press “Close” button to disable the alarm, it will not alert
within set date.