Service manual

1-24 June 21, 2004
GENERAL NP88 FLEX
Maintenance
3. Twist the disassembly tool counterclockwise while lifting it up toward the back
housing.. The latch should begin to unsnap.
4. Separate the front and back housin g by liftin g the back housing up and away
from t he front housing as shown in Figure 1-12. The back housing lip at t he
LCD end will separate last.
Replacing the Back Cover
1. Insert the lip of t he back housin g below t he up per inside edge of the front
housing disp la y area .
2. Cen ter the back housing a nd push it down towa rd the front housing, keeping
the lip of the back housin g in place.
3. Squeeze the back housi ng toget her wi th the fron t housing until all of the snaps
have engaged.
4. Align the ba ttery door hinges with the recesses in the bottom of the housing.
5. Press t he battery door in to the recessed area until it snaps in t o place.
6. Close the battery door by sliding it back into position, in the dir ection opposite
the arrow, until it snaps into position.
7. Engage the batte ry door lock as explained in the earlier procedure.
Removing/Replacing the Belt Clip
1. Pullt up the belt clip from the direction as shown in Figure 1-13. to remove it.
2. Squeeze the clip-holderon the belt clip together with the slot on the vack housing until
all of the snaps have engaged.
Figure 1-12.