Service manual

1-8 June 21, 2004
GENERAL NP88 FLEX
Product Overview
Standard Features
Tone-Alert Operation
This is the standard operating modeofthepagerinwhich it responds to a sequence
of signals that includes the address that matches the address information pro-
grammed into the pager’s code plug. The pager responds to the correct paging
sequence by emitting an interruptible alert tone and by displaying the number of
unreadmessages. Whenthepager’s messages are read, thedisplay shows the time
of day.
The pager receives tone-only and numeric pages. When a message is received that
does not contain numeric data, tone only displays. Tone Only pages show a tone
number associated with the sender.
pager off ?
Press to turn pager off.
set alert ?
Press to display selected alert type. Press to sample alert
types. Press again to select an alert type and return to the Status
screen.
set alarm ?
Press to select on/off sequence. on or off flashes. Press to
turn alarm on or off. Press to select the hour. Press to change
the hour. Press to select minutes. Press to change the first digit
of minutes. Press . Press to change the second digit of minutes.
Press . Press to select
am or pm. Press twice to return to the
Status screen.
set time ?
Press to select the hour. Press to change the hour. Press to
select minutes. Press to change the first digit of minutes. Press
. Press to change the second digit of minutes. Press . Press
to select
am or pm. Press twice to return to the Status screen.
set date ?
Press to select the month. Press to change the month. Press
to select the day. Press to change the day. Press to repeat
setting the date, if desired. Press twice to return to the Status
screen.
protect ?
Press to protect the message being read. Press while reading
a protected message to display the unprotect ? prompt.
unprotect ?
Press to remove protection of the message being read.
erase all ?
Press to erase all read, unprotected messages.
Table 1-2. Menu Prompts (Continued)
Prompt Response
The following information describes the standard features of the NP88 FLEX pagers.
Some pager features are programmable using the proper Pager Programming Software
(PPS). The PPS User's Guide listed in "Related Publications" provides
additional information about programmable features.