Instruction manual

11
Instructions for the installer
3
INSTRUCTIONS FOR
THE INSTALLER
3.1 - GENERAL WARNINGS
AThis boiler has to be destined for the use for
which it has been expressively designed for.
Any other use shall be considered improper
and therefore dangerous.
This boiler is designed to heat water at a
temperature inferior to boiling point at an
atmospheric pressure.
WARNING!
These appliances are exclusively designed
to be installed inside adequate boiler rooms.
Before installing the boiler the following
points have to be carried out by a competent
engineer:
a) The whole system should be thoroughly
flushed in order to remove any residual
dirt or grime which could compromise the
good operation of the boiler, even from a
hygienical point of view.
b) Check that the boiler has been preset for
operating with the gas type available.
This is verifiable via the indication on the
packaging and on the data badge;
c) Check that the chimney/flue pipe has an
adequate draught, does not have any
constrictions, and that no other applian
ce's flue outlets have been fitted, unless
the chimney is serving more than one
heating appliance, according to the spe
cific standards and regulations in force.
The connection between the boiler and chim-
ney/flue outlet can be made only after this veri-
fication has been carried out.
WARNING!
In rooms where aggressive vapours or dust
is present, the appliance must operate
independently from the air present in the
boiler's location room!
WARNING!
The appliance must be installed by a registe-
red engineer or gas installer.
The boiler must be connected to a heating
system which is compatible to its performance
and output.