User's Manual

6 080306A-1

7. USOC jack type is RJ11C and the compatible jack is part 68 compliance.

NOTICE: If your home has specially wired alarm equipment connected to the

telephone line, ensure the installation of this [equipment ID] does not disable

your alarm equipment. If you have questions about what will disable alarm

equipment, consult your telephone company or a qualified installer.

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful

interference, and, (2) this device must accept any interference received,

including interference that may cause undesired operation. Privacy of

communications may not be ensured when using this phone.

Changes or modifications not expressly approved in writing by

orthwestern Bell Phones may void the user's authority to operate this

equipment.

NOTE: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmfu

interference in a residential installation. This equipment generates, uses an

can radiate radio frequency energy and, if not installed and used i

accordance with the instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in

articular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

. Reorient or relocate the receiving antenna.

. Increase the separation between the equipment and receiver.

. Connect the equipment into an outlet on a circuit different from that to

which the receiver is needed.

. Consult the dealer or an experienced radio/TV technician for help.