User's Manual

14 080306A-1
(Figure 4)
2. Drive a screw into each of the holes. Tighten them to the end of the screw
lines, only leaving the smooth part of the screw head outside the wall.
3. Place the unit onto the screws, then slide it down firmly to fasten the base
securely.
Uninstalling the Wall Mount Bracket
To remove the wall mount bracket from the base unit, pull it forward as shown
in Figure 5.
POWER CONNECTION
CAUTION: You must use a Class II, 120 Volt AC/6 Volt DC adaptor
that delivers at least 250mA for base unit and 250mA for charger. The center tip
must be positive and the plug must correctly fit the base unit’s DC 6V 250mA
jack and fit the charger DC 6V 250mA jack.
1. Plug the AC adaptor into a standard AC outlet.
2. Insert the small plug into the DC 6V 250mA jack on the rear of the base
unit and Insert the small plug into the DC 6V 250mA on the rear of the
charger as shown in Figure 6.
(Figure 5)