OPERATING INSTRUCTIONS FOR THE UA5000 AUTOFEED DRILLING SYSTEM To get the best possible performance from your new Magnetic Drilling Machine, please read this carefully BEFORE using the drill. The UA5000 Autofeed machine is part of the range of specialist engineering products.
INTRODUCTION CONTENTS BEFORE STARTING Congratulations on the purchase Page 3. Warnings and Safety Instructions Read these instructions carefully before operating, maintaining or servicing this tool. multi-purpose magnetic base drill. Page 4. This is a high quality product with Broach Cutting Concept & Technical overview Please keep these instructions in a safe accessible place. unique features that make it the Page 5.
TECHNICAL OVERVIEW BROACH CUTTING Power required Cutter capacity - 12 - 50mm (HSS) No load speeds - 350/650 rpm Power consumption - 1150w Clamping force Size (L/W/H) Weight Voltage - 720kg - 330 x 268 x 565mm - 21 kg - 240v MACHINE PARTS Cradle slide Cradle slide adjustment screws Capstan Speed change switch Cutting Time Cutting Time ALSO INCLUDES: Warranty, Carrying case, Allen keys, Safety strap, Cutting Oil • The easy to use and rugged design makes the UA5000 a cost effective solution to drillin
PREPARATION DRILLING Ensure that the machine is disconnected from the power supply before attempting to maintain the machine or to fit or change the cutter. • Connect the machine to the power source and turn on the supply. INSERT PILOT PIN. The pilot pin is used to align the cutter and eject the slug on completion of the cut. Ensure the pilot is the correct length and diameter for the cutter being used and is sharp. Slide the pilot through the hole in the centre of the cutter shank. FIT THE CUTTER.
ASSEMBLY DIAGRAM PARTS LIST WARNING - This illustration is for information only, users should never disassemble the machine.
EU DECLARATION OF CONFORMITY MAINTENANCE WARNING - SWITCH OFF AND REMOVE POWER PLUG FROM THE SUPPLY DURING MAINTENANCE AND INSPECTION CAUTION - CHECK REGULARLY AND TIGHTEN SCREWS. ALL ANY PARTS LOOSE • Occasionally apply a few drops of oil to the rack teeth. • After repeated use, the cradle may become loose. This is remedied by adjusting the tension screws on the side of the body.
FOR THE BEST RESULTS USE CUTTERS high speed steel cutters are available in two standard cutting depths - 30mm and 50mm - in diameters of 12 to 100mm in 1mm increments, specifically designed for use with the Unibor range of electro-magnetic drilling machines. The range also includes tungsten carbide tipped cutters for drilling harder, difficult to machine and exotic materials.
