Daim Ntawv Qhia Tus Neeg Siv
Table Of Contents
- MSO/UPO2000 Series
- Copyright Information
- 1. Safety Requirements
- 2. Introduction of MSO/UPO2000 Series Digital Phosphor Oscilloscope
- 3. Getting Started Guide
- 3.1 General Inspection
- 3.2 Before Use
- (1) Connect to the Power Supply
- (2) Boot Check
- (3) Connect Probe
- (4) Function Check
- (5) Probe Compensation
- When the probe is connected to any input channel for the first time, this step might be adjusted in order to match the probe and the input channel. Probes that are not compensated may lead to measurement errors or mistake. Please follow the following ...
- 4. Front Panel
- 5. Rear Panel
- 6. User Interface
- 7. Touch Screen
- 8. Operation Menu
- 9. Remote Control
- 10. Troubleshooting
- 11. Appendix Contact Us
Quick Start Guide MSO/UPO2000 Series
4 / 18
Instruments.uni-trend.com
present, all conditions must be met before this device will function
properly.
AC
Alternating current of device. Please check the region’s voltage range.
DC
Direct current device. Please check the region’s voltage range.
Grounding
Frame and chassis grounding terminal
Grounding
Protective grounding terminal
Grounding
Measure grounding terminal
OFF
Main power off
ON
Main power on
Power
Supply
Standby power supply: when the power switch is turned off, this device
is not completely disconnected from the AC power supply.
CAT I
Secondary electrical circuit connected to wall sockets through transformers or
similar equipment, such as electronic instruments and electronic equipment;
electronic equipment with protective measures, and any high-voltage and low-
voltage circuits, such as the copier in the office
CAT II
CATII: Primary electrical circuit of the electrical equipment connected to the indoor
socket via the power cord, such as mobile tools, home appliances, etc. Household
appliances, portable tools (e.g. electric drill), household sockets, sockets more than
10 meters away from CAT III circuit or sockets more than 20 meters away from CAT IV
circuit
CAT III
Primary circuit of large equipment directly connected to the distribution board and
circuit between the distribution board and the socket (three-phase distributor circuit
includes a single commercial lighting circuit). Fixed equipment, such as multi-phase
motor and multi-phase fuse box; lighting equipment and lines inside large buildings;
machine tools and power distribution boards at industrial sites (workshops)
CAT IV
Three-phase public power unit and outdoor power supply line equipment. Equipment
designed to “initial connection”, such as power distribution system of power station,
power instrument, front-end overload protection, and any outdoor transmission line
Certificati
on
CE indicates a registered trademark of EU
。
Certificati
on
UKCA indicates a registered trademark of UK.
Certificati
on
ETL indicates a registered trademark of Intertek.
Waste
This product complies with the marking requirements of WEEE Directive
(2002/96/EC). This additional label indicates that this electrical / electronic product
must not be discarded in household waste.
EFUP
This environment-friendly use period (EFUP) mark indicates that
dangerous or toxic substances will not leak or cause damage within this
indicated time period. The environment-friendly use period of this