User Manual
a)Select Burst
Start Burst function
Press Menu → Burst to start function of pulse. After pulse train function is used,
UTG2000B function/arbitrary waveform generator will output pulse train with the current
setting.
Figure 4-46 Select BURST function
Select waveform
N cycle mode supports sine wave, square wave, ramp wave, pulse wave and arbitrary
wave (except DC).
Gating mode supports sine wave, square wave, ramp wave, pulse wave, arbitrary wave
(except DC) and noise.
Infinite mode supports sine wave, square wave, ramp wave, pulse wave and arbitrary
wave (except DC).
After pulse train function is started, press Carrier → Type to select frequency sweep
waveform. The interface that pops up is shown in the figure below:
Figure 4-47 Select waveform
84