User Manual

4)Enable channel output

Press CH1 button start channel 1 output quickly. Or enable output by pressing Utility and

then CH1 Setting . After channel output is opened, backlight of CH1 button is on, and on

the right side of channel information label, the font “OFF” changes to “Line”, meaning open

channel output.

Check the shape of frequency sweep waveform through oscilloscope, which is shown in

the figure below:

Figure 4- 45 Observe frequency sweep waveform with oscilloscope

4.3 Output Burst

Signal generator can create a waveform with designated recurring number (known as pulse

train). UTG2000B supports control of pulse train output with internal, external or manual

trigger, and three types of pulse train, including N cycle, gating and infinite. It can generate

pulse train for sine wave, square wave, ramp wave, pulse wave, arbitrary wave (except DC)

and noise (only applicable to gating pulse train). The modulation mode of the two channels

is mutually independent. You can configure same or different modulation mode for channel

1 and 2.