User Manual

4.2 Output Frequency Sweep Waveform
When selecting frequency sweep mode, the output frequency of function/arbitrary waveform
generator changes in a linear or logarithmic way from starting frequency to stop frequency
in designated frequency sweep time. Trigger source can be internal, external or manual;
it can generate frequency sweep output for sine wave, square wave, ramp wave and arbitrary
wave (except DC). The modulation mode of the two channels is mutually independent.
You can configure same or different modulation mode for channel 1 and 2.
a)Select Frequency Sweep
Start frequency sweep
Press Menu → Sweep to start frequency sweep. After frequency sweep is used, UTG2000B
function/arbitrary waveform generator will output frequency sweep waveform with the
current setting.
Figure 4-31 Select SWEEP function
Select frequency sweep waveform
After frequency sweep is started, press Carrier to select frequency sweep waveform.
The interface that pops up is shown in the figure below:
Figure 4- 32 Select frequency sweep waveform
76