User Manual

g)Set ramp wave
Default symmetry degree of ramp wave: 100%.
Steps for setting a ramp wave with 10 kHz frequency, 2V amplitude, 0V DC offset and
50% duty ratio:
1.Press Menu Wave Type Ramp Param
2.Select the parameter to enter edit mode, then input required numbers and select unit.
Note: When enter symmetry degree value, press 50% label at the bottom of the display.
h)Set noise wave
Default noise: Gauss noise with amplitude 100mVpp and DC offset 0mV.
Steps for setting Quasi Gauss noise with 300mVpp amplitude and 1V DC offset:
Press Menu Wave Type Noise Param to enter parameter editing mode. After
setting, enter number and unit.
12