User Manual

UTE9802 Programming manual
*IDN?
This query command reads the identification string of the instrument. Return value example：
UTE9802，
SN202111051001，V1.12，V0.02
MEAS:VOLT？
Read the measured voltage value.
Return value example：220.0V，OL（Out of
range, the same below）
MEAS:CURR？
Read the measured current value.
Return value example：5.12A or 500.1mA
MEAS:POW？
Read the measured power value. Return value example：350.02W
MEAS:PF？
Read the measured power factor value. Return value example：0.501
MEAS:FREQ？
Read the measured frequency value. Return value example：50.01Hz
MEAS:ALL？
Read back all measured values at one time: measurement mode, voltage,
current, power, power factor, frequency, separated by commas.
Example：AC,220.1V，5.01A，1103.2W，0.901，49.99Hz
Example：DC,220.1V，5.01A，1103.2W
Example：RMS,220.1V，5.01A，1103.2W，0.998，49.99Hz
MEAS:MODE？
Read the measurement mode. Return value example：AC，DC，RMS（AC+DC）
SET:MODE XXX
Set the measurement mode. Return value example：SUCCESS，ERR
RANG:VOLT？
Read the voltage range. Return value example：AUTO 、
75V、150V、300V、600V
RANG:VOLT XXXX
Set the voltage range. Return value example：SUCC，ERR
RANG:CURR？
Read the current range. Return value example：AUTO 、500mA、2A、8A、20A
RANG:CURR XXXX