User Manual

press F5 to select “All parameters” to display all

voltage/time measurement parameters. User ca

press F2 to select channel to measure. (Channel is

ineffective until opening.) User can press F1 Retur

to parameter measurement display menu if not

altering current measurement category. The first

example: Steps are as follows if displayin

measured peak value of CH2 channel in F1 area

1. To press F1 key Enter into measurement

category selection menu

;

2. To press F2 to select CH2

;

3. To press F3 to select voltage

;

4. To press F5 (shown in the second page, 2/4) to

see that F3 position is “peak value

”

5. To press F3 to select “peak value” and return to

parameter measurement display menu

automatically

;

Peak value is displayed in F1 area on the

homepage of measurement menu

The secondexample: Setup of delay measurement:

Delay measurement function is used for interval

between ascending edges of 2 information sources

namely, interval from ascending edge of the first

cycle of a certain information source to that of the

first cycle of additional information source

Measurement steps are as follows

1. To refer to above example and select area

displayed by delay measurement value after

entering into measurement menu (shown in 3/

page of time category)

;

2. To select reference information source of CH1

then select delay information source of CH2

;

3. To select reference information source of

then select delay information source of CH2

;

4. To press F5 to confirm that delay measurement is

displayed in selected area

Oper ating Man ual fo r UTD 2000/3000