Product specifications

Operating Manual for UTD2000/3000
72
Chapter 3: Application Example
2
The first example: Measurement of simple signal
It has to observe a unknown signal in the circuit for
quick display and measurement of signal frequency
and peak value.
vertical or horizontal gear on above basis so that
waveform display can meet related requirements.
.Automatic measurement of signal voltage and
time parameters
Digital storage oscillograph can measure most of
display signals automatically. Please operate
according to following steps for measurement of
1. Please operate according to following steps
signal frequency and peak value.
for quick signal display:
① To press MEASURE key to display automatic
1. Please operate according to following steps
measurement menu;
for quick signal display:
② To press F1 to enter into measurement menu
① To set probe menu attenuation coefficient to 10*
category for selection;
and set switch on the probe to 10*.
③ To press F3 to select voltage category;
② To connect CH1 probe to measured point of
④ To press F5 to turn to 2/4 page then press F3 to
circuit.
select measurement type of peak value;
③ To press AUTO button.
⑤ To press F2 to enter into measurement menu
Digital storage oscillograph can set automatically
category for selection then press F4 to select time
for the best waveform display. You can also adjust
category
;