Product specifications

Operating Manual for UTD2000/3000

Please press [F2] to set band width limitation to ON

for great attenuation of high-frequency component

and noise of more than 20MHz contained by

measured signals. Waveform display is also shown

in following figure.

3. Setup of multiplying factor for probe：

It has to set probe attenuation coefficient in

operation menu of channel to coordinate with

attenuation coefficient setup of probe. Probe

coefficient in channel menu shall be set to 10× if

probe attenuation coefficient is 10:1. It has to

analogize to guarantee correct voltage.

Volt/grid gears of vertical deflection coefficient can

be divided into coarse tuning and fine tuning.

Please refer to following figure for setup and

vertical gear when using 10:1 probe.

Figure 2－5Waveform display when opening

bandwidth limit

bandwidth

limit

Probe

attenuation

coefficient

Figure 2－6 Probe attenuation coefficient shown

in channel menu