Product specifications

Operating Manual for UTD2000/3000
(Note: Input signal still shall be connected to channel
circuit under such mode although waveform is not
Figure 2－3 Synchronous obstruction of DC and AC
components of signal
18
Ground coupling
setup
2. Setup of channel bandwidth limit：
Input one sine signal of about 40MHz for CH1 as an
example. It has to press [CH1] to open CH1 channel
then press [F2] to set bandwidth limit to OFF.
Channel band width is full band width to pass
through high-frequency components contained by
measured signal. Waveform display is also shown
in following figure.
Figure 2－4 Waveform display when closing
bandwidth limit
Bandwidth
suppression
20MHz
Bandwidth suppression icon