Product specifications
1. Press F1 to DC to pass through DC and AC
Measured signal is a sine signal with DC component components of measured signals of CH1 channel.
by taking exerting signal to CH1 channel as an Waveform display is also shown in following figure:
example.
To press F1 to select AC and AC coupling mode. DC
component contained by measured signal will be
obstructed. Waveform display is shown in following
figure.
Figure 2-2 Synchronous display of DC and AC
components of signal
Press [F1] to select grounding and set channels to
grounding mode. DC and AC components contained
by measured signals will be obstructed. Waveform
display is shown in following figure:
displayed on the screen.)
Setup of channel coupling:
17
Operating Manual for UTD2000/3000
Figure 2-1 Jammed DC component of signal
Setup of
AC coupling
DC coupling
setup