Product specifications

Operating Manual for UTD2000/3000
5
General inspection Please pay attention to packages and report to
It is suggested to inspect the instrument by transportation department and UNI-T distributor if
following steps when getting a new UTD2000/3000 machine damage is caused by transportation.
series digital storage oscillograph.
1. To check if there is damage due to transportation Function inspection
or not.
Please replace carton or foaming plastic protection
cushion with severe damage instantly.
1. Connect the power supply
2. Please inspect fitting details and shown it in
You can supply power to the machine and voltage is AC
“Fittings of UTD2000/3000 series digital Storage
100V to AC 240V. Frequency is 45Hz to 440Hz. It has
Oscillograph” shown in the manual. You can check
to press [UTILITY] menu and [F1] for self-correction
if there are deficient fittings or not by referring to
after power supply 30 minutes after operation of hot
it. Please contact UNI-T distributor or local agent
machine so that digital storage oscillograph operates
if there are deficient or damaged fittings.
under the best status. As shown in Figure 1
－4, please
3. Please inspect the entire machine and contact UNI-T
enter into next page and press [F1] to call out ex-
distributor or local agent for damaged appearance,
factory setup.
abnormal operation or failing to pass performance test.
UNI-T will arrange maintenance or replacement.
Please carry out once fast function inspection to
check if the machine operates normally or not.
Please operate according to following steps
：