User Manual

88
UTD1000L
User Manual
Interface Setup
To set up the display interface for the Oscilloscope,
do the following:
1. Press SHIFT shift icon shows on uppert
right corner of display
2. Press CONFIGURE to enter into diplay
configuration menu
,
.
;
Type
Mode
Func Switch
Voltage
Independent
Tracking
Channel
Trigger
Use the cursor to
measure the voltage
Move each cursor
independently
Move two cursors
simultaneously and keep
unchanged
ΔV
Use arrow buttons to set
the target to channel
waveform
Use arrow buttons to set
the target to trigger level
Use arrow buttons to set
the target to the cursors,
press SELECT to select
between Cursor 1 and
Cursor 2
;
;
.
Table 6-16
Menu
Settings
Description
Cursor