User Manual

78
Figure 6-19 Display Selected Parameters
Parameter selection is to measure
parameter immediately. There are 19 types of
parameter measurements for UTD1000CL and 22
types available in UTD1000DL Under general
circumstances not all parameters but just
some of them are required to be measured.
Therefore the users can customize their
measurements as expected. The software can
select up to 4 parameters displayed on the screen.
Auto Parameter Measurements
Figure 6-20 Voltage Measurement
The voltage parameters that the Oscilloscope can
automatically measure include:
Voltage measured
fr
om the highest point of waveform to the zero
ground
Voltage measured from
the lowest point to the ground
Voltage measured from the flat
top to the ground.
Note
Maximum Value (Vmax
Minimum Value Vmin
Top Value (Vtop
:
.
, ,
):
( ):
):
UTD1000L
User Manual