User Manual

UTD1000L
User Manual
Term Explanation:
Display Format:
Update Rate:
Slow Scan Mode:
VECTOR Display fills out all
blanks between neighboring points DOT
Display just shows sample points
The times that the oscilloscope
updates the waveforms per second. it reflect how
fast the Oscilloscope could allow you to observe
signal dynamic change.
Y-T Mode In this mode Y axis represents
voltage and X axis for the time
When the timebase is set at
50ms/div or lower the Oscilloscope will enter
into slow scan mode This mode is applied to
observe low frequency signal It is
recommended that channel coupling is set to
DC
The section below introduces in details the
powerful auto measurement funct
ion owned by
the Oscilloscope Press MEASURE button to
open auto measurement menu, see the table
below
Figure 6 15A UTD1000CL Auto Measurement
Menu
,
.
: ,
.
,
.
- .
.
.
:
-
Setting Auto Measurements
74