User Manual

ManualsBrandsUNI-T ManualsHandheld OscilloscopesHandheld Oscilloscope, 2x 25MHz, 250MSPS

UTD1000L

User Manual

Setting Probe Factor

Changing Timebase

Moving Waveforms Horizontally

×.

～

- :

～

;

- :

～

, 6

- ,

To match with the probe factor on the probe,

you need to set up corresponding factor in channel

menu. For example, the probe factor is 10:1

please set Probe option in the menu to 10

Do the same setting for other selected probe

factor in order to ensure accurate voltage

reading

Under channel menu, press F3 to set up

probe factor To set up probe factor for another

channel please press CHANNEL again and then

the F3 button.

Probe Attenuation Factor VS Menu Option, see

following table:

Table 6-2B

Press s/ns button slow down or speed up the

scan rate from 10ns or 5ns/div 50s/div

Notes: For 25MHz bandwidth mo

dels 10ns/div

50s/div 50MHz bandwidth Models 5ns/div

50s/div

Press Left and Right buttons to adjust pretrigger

depth. The trigger location is usually set at

horizontal center on the screen. With the

adjustment you can observe div pretrigger

and delay data Through moving the waveform

horizontally, more trigger information can be

viewed, which let users know more about

pretrigger situation. For instance, by observing and

analyzing pretrigger data of glitches occurring in

circuit start up you can trace down the cause

to the glitches

Setting Horizontal System

Probe Attenuation

Factor

1:1

10:1

100:1

1000:1

Menu Option

100

1000