User Manual

UTD1000L
User Manual
52
Figure 5-22 Measuring Capacitanc in Relative
Mode
The multimeter defaults at auto mode. To access
manual ranging, operate as follows:
1. Press V or R button, and measure mode
option is AUTO
2 Press F2 to select manual measure mode
then the ranging mode will change into Manual
status accordingly
3.Under manual ranging mode, keep pressing F3
button to reach up to the highest range
after that, then the selected range jumps directly
to the lowest range and circulates again.
The currently selected range shows just above
measuring readings.
4 Press F2 button, Auto icon shows on left upper
display in
dicating the multimeter has
returned to full autoset mode
Figure 5-23 Manual Ranging
.
. ,
.
,
.
,
.
Selecting Manual Auto Ranging
/