User Manual

UTD1000L
User Manual
40
To measure DC current lower than 400mA do the
following
1 Press I button to set measurement type to DC
Current
2. Press F3 button to select mA range, and
measurement unit will be mA
3. Plug test lead connectors into input terminals
(Black to COM and Red to mA
4 Connect test leads to tested points then take
DC current reading
Figure 5-8 Measuring DC Current lower than 400mA
To measure DC current greater than 400mA do the
following
1 Press I button to se measurement type to DC
Current
2 Press F3 button to select A range, the
measurement unit will change into A accordingly.
3 Plug10A Current divider module U
T-M07
into input terminalsCOM and mA then
connect black and red test lead connectors
respectively to the module UT-M07
4 Connect test leads to tested points than take
the DC current reading
If test leads are connected to COM
and without use of 10A Current divider
module UT-M07 when measuring current
greater than 400mA, the fuse in the product will be
burnt out. Please have the fuse replaced by
qualified personnel if the incident happens
,
:
.
.
.
/ )
. ,
.
,
:
.
.
.
. ( )
/ ,
( )
. ,
.
:
( )
μA μA
μA /mA
Warning