User Manual

UTD1000L
User Manual
37
Testing Diodes Testing for Continuity
, :
.
.
.
.
).
,
,
.
, :
.
.
. .
.
).
. .
.
To test the diode do the following
1 Press R button to set the measurement type to
Resistance
2 Press F1 button to select Diode option.
3 Plug test lead connectors into multimeter input
terminals (Black to COM and Red to
4. Connect test leads to the tested diode then
forward voltage drop reading for the diode
displays accompanied by the
unit V
To check the continutity do the following
1 Press R to set the measurement type to
Resistance
2 Press F1 button to select Continutity
3 Plug test lead connectors into multimeter
input terminals (Black to COM and Red to
4 Connect test leads to tested points The
mul
timeter will beep if tested resistance
between tested points is lower than
Figure 5-3 Testing for Continuity
V/Ω V/Ω
70Ω
measurement
Fgiure 5-2 Testing Diode