User Manual

UTD1000L
User Manual
21
Note: Run/Stop Data Acquisition
1. Under autoset mode trigger mode is set to
Auto and cannot change
2. Once you are in autoset mode following
settings are forced to execute
1 The Oscilloscope will switch into main
timebase status if the current display isn t under
this status
2 The coupling mode will be set to AC
mode and allows no change
3. Any adjustment on the vertical scale or
horizontal timebase of the Oscilloscope that has
changed waveform vertical or horizontal location
will make the Oscilloscope automatically exit
autoset mode
To stop the data acquisition
1. Press RUN/STOP button, the Oscilloscope
stops data acquisit
ion and STOP indicates on
the upper display
2. Repress RUN/STOP then the oscilloscope
will restart the acquisition
,
“ ” .
,
:
( )
'
;
( )
.
.
:
;
,
.
Figure 4-10 Stop Data Acquisition